Straightforward 2:1 recovery for common cable and component diameters
← All product families
SLEEVANTA product family reference
HS-SW2-GPGeneral-Purpose Single-Wall Heat-Shrink Tubing
A practical 2:1 tubing family for routine electrical insulation, cable organization and light mechanical protection. SLEEVANTA evaluates available manufacturing sources against the required dimensions and operating conditions.
ILLUSTRATIVE SECTION
2:1Single-wall polyolefin
ConstructionSingle-wall polyolefin
Shrink ratio2:1
Operating range−55°C to +105°C
Nominal expanded IDØ0.5–50 mm
Why this family
A practical construction for a defined job.
Final size, color, packaging, performance and document status are confirmed in the quotation for the proposed manufacturer's model.
Supports insulation, bundling, identification and light strain relief
Requested size, color, cut length and packaging are quoted subject to source availability and MOQ
Samples and technical data are reviewed subject to source availability and sample terms
Representative sourced range
Technical data for initial selection.
Values below describe the representative source range currently reviewed. They are not blanket specifications for every possible size, color or manufacturer's model.
Selection note
The initial general-purpose reference configuration is non-flame-retardant. If flame performance, UL 224 or VW-1 is mandatory, request a separate model match.
- Construction
- Single-wall polyolefin
- Nominal shrink ratio
- 2:1
- Operating temperature
- −55°C to +105°C
- Recovery begins
- Approx. 70°C
- Full recovery guidance
- Approx. 105–200°C, max 3 min (model-specific)
- Nominal expanded ID range
- Ø0.5–50 mm
- Typical voltage option
- 600 V
- Longitudinal change
- Within ±5% (manufacturer reference)
- Dielectric withstand
- 2,500 V / 1 min
- Breakdown strength
- ≥ 15 kV/mm
- Volume resistivity
- ≥ 1 × 10¹⁴ Ω·cm
- Tensile strength / elongation
- ≥ 10.4 MPa / ≥ 200%
How to specify
Send what you know.
A current part number, drawing or application photo is helpful, but it is not required to start a model match.
- 01
Maximum diameter the tubing must pass over
- 02
Minimum diameter after installation
- 03
Required operating-temperature range
- 04
Application and substrate material
- 05
Required color, cut or reel length and packaging
- 06
Quantity, delivery country and mandatory documents
Documentation
Evidence follows the exact proposed model.
Manufacturer technical data and dimensional tables are available for the representative source range. Reports may cover only an identified sample, material, size or color. UL recognition, flame performance and other compliance evidence are checked separately for the exact quoted model.
- Proposed manufacturer and part number identified in quotation
- Dimensions and packaging confirmed
- Available documents and their exact scope checked when requested
- MOQ, sample option and lead time stated